Jaguar I-Pace EV400 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter #1
I just wanted to show how the Dust (Mud) flaps look on the I-Pace.
And for anyone wanting added protection for the AC charge port, I had
this Cap Plug 3D custom printed. I could not find one online so I had it
designed and printed per my spec. (at home):wink2:
 

Attachments

  • Like
Reactions: iMarkEV

·
Registered
Joined
·
24 Posts
Nice job!
 

·
Registered
Joined
·
52 Posts
I just wanted to show how the Dust (Mud) flaps look on the I-Pace.
And for anyone wanting added protection for the AC charge port, I had
this Cap Plug 3D custom printed. I could not find one online so I had it
designed and printed per my spec. (at home):wink2:

Looks great! Did you install these yourself? I've seen the mud flaps on the bay but did not purchase because none of the sellers could provide me with installation instructions.
 

·
Registered
Joined
·
199 Posts
Discussion Starter #4
Mud flaps were installed by dealer.:wink2:
 

·
Premium Member
19 I-pace HSE Polaris/Fuji white with most options and a lot of accessories
Joined
·
850 Posts
Rear mud flap install instructions: JAGUAR Accessory Fitting Instructions
Front mud flap install instructions: JAGUAR Accessory Fitting Instructions

I've pondered putting them on. I wonder how they'll cause more snow/ice build up in winter. Some sites say adding mud flaps will reduce the aerodynamics and reduce the range. What? Maybe a 1/8 of mile?

Adding mud flaps was suggested as a method to reduce paint chipping problems on model T M3 cars that were delivered to Finland. Apparently the paint was tested and found to be too thin and not hard enough to meet the government mandated standards.

Are you going to market the socket plugs?
 

·
Registered
Joined
·
550 Posts
I just wanted to show how the Dust (Mud) flaps look on the I-Pace.
And for anyone wanting added protection for the AC charge port, I had
this Cap Plug 3D custom printed. I could not find one online so I had it
designed and printed per my spec. (at home):wink2:
Meldev##44, care to share that file/spec for the plug? Love the idea and my 10 y/o son (for whom I bought the 3D printer) will be super excited to print it for me!
 
1 - 6 of 6 Posts
Top